belt tension
英 [belt ˈtenʃn]
美 [belt ˈtenʃn]
网络 皮带张紧
双语例句
- Generator Belt Tension Adjust Bracket
发电机皮带张力调整托架 - The analytical results show that the influence of the variation of belt tension is most obvious, and that of the slotting angle and run-up angle are secondary on the curvature radius.
张力的变化对曲率半径的影响最大，成槽角及抬高角的变化对曲率半径的影响也较大。 - The proportional direction valve and the proportional relief valve were adopted to timely control the belt tension and its working principles were introduce.
分别采用比例方向流量阀和比例溢流阀来实时控制输送带张力，并分别介绍了其工作原理。 - Loosen the accessory drive belt tension and remove the belt from the power steering pump ( refer to Group 07, Cooling Systems for proper procedures).
放松辅助驱动皮带，从动力转向泵上拆下皮带（有关程序，请参阅单元07，冷却系统）。 - The lab test result shows that this system is feasible for dynamic test of belt tension.
系统能实现输送带静止及运动过程中的沿线张力测试。 - The belt-tensioning and deviation-regulating device of a belt conveyer simple structure, strong practicality, and obvious effects of solving belt tension and regulating deviation.
本装置结构简单，实用性强，解决皮带张力和调偏效果明显。 - Inspect the drive belt for tension, wear and damage.
检查传动皮带是否处在绷紧状态，是否有磨损和损坏。 - This paper introduces the design of a belt tension measuring tool and its application research.
介绍了一种皮带张紧力检具的设计及应用研究。 - Some movement of sprockets and timing marks as belt tension is adjusted is normal.
当调整皮带张力时，链轮与正时记号有些许移动是正常的。 - However, because unsuitability and fluctuation of the steel belt tension as well as the shape irregulation of the steel belt, there will exist some influence on precision.
然而，由于钢带张力不适当或张力波动较大以及形状不均等各种原因，会对钢带卷取精度造成一定的影响。 - By improving slack adjuster, this paper adjusts the runing working condition of conveyor belt tension, reduces running trouble of conveyor belt, satisfieds manufacture require.
通过对带式输送机拉紧装置的改造，调整了输送带张力的运行工况，降低带式输送机运行事故率，满足生产要求。 - Constant Spring Type-selection& Constant Hangers Designing and Installation The Calculation of Rubber Belt Tension for Belt Conveyor in Constant Automatic Tight Unit
恒力弹簧选型及恒力弹簧支吊架的设计与安装在采用恒力自动拉紧装置时带式输送机胶带动张力计算 - A new method of on-line monitoring the steel cord conveyor belt tension
钢绳芯胶带张力超限在线监测方法研究 - A new method of on-line monitoring the steel cord conveyor belt tension is presented in this paper, which is based on the belt's flexibility and analysis of the tension.
提出一种用于钢绳芯胶带张力在线监测的新方法，介绍了其基于挠性变形和受力分析的测量原理及1套实用装置。 - Online dynamic test of conveyor belt tension
输送带张力的在线动态测试 - First of all, the paper analyses the structure and application of the take-up system, expounding its merits and demerits in theory and in practice, finds out the regularities of belt tension distribution by the analyses of tension of belt in the process of belt conveyor running.
本文首先分析了传统皮带拉紧装置理论和实际应用上的优缺点，从皮带传送过程中的张力分析入手，找出皮带张力分布规律。 - The author proposes a method for calculating the belt tension between the front and the rear driving drums of a double driving drum belt conveyor when calculating the belt tension on the basis of permissble deflection of the section of the belt under load.
提出了双传动滚筒胶带运输机按承载段胶带容许挠度计算胶带张力时，前、后两传动滚筒之间的胶带张力求法。 - The lower level computer mainly completes collection and display of belt tension and velocity signal of belt conveyor.
下位机主要完成带式输送机胶带张力、速度信号的采集和显示。 - Recognition~ ( TM) Passive Occupant Detection System with Belt Tension Sensor
被动乘员安全检测系统-附有安全带张紧传感器 - Also presented in the paper are the determination of belt pulleys, the selection of belt type, the calculation of belt nominal length and the testing of belt tension after the determination of motor power.
定出电机功率后，进一步介绍皮带轮大小的确定，皮带型号选择、皮带名义长度的计算及皮带张紧力的调试等。 - The Calculation of Rubber Belt Tension for Belt Conveyor in Constant Automatic Tight Unit
在采用恒力自动拉紧装置时带式输送机胶带动张力计算 - The paper analyses the distribution regulation of air cushion field press and press grade in convex curve and concave curve of air cushion belt conveyor and discusses the curve radial R1 and the effect of belt tension on air cushion field major factors.
本文分析了气垫带式输送机在凸凹弧段运行时，气垫场的压力、压力梯度的分布规律，并讨论了凸凹弧段曲率半径R1，胶带张力对气垫场主参数的影响。 - Also the belt tension velocities obtained with two lumped element models and a continuous body model agree very well.
对离散单元模型和连续介质模型等三个模型之间的张力波波动速度进行比较，结果十分吻合。 - A formula for calculating rational minimum length of turn-over section in return side of conveyor belt is deduced after analysing factors, such as belt tension under normal working condition, additional stress in belt edge and belt weight, etc.
通过分析输送带在正常工作状态的张力，在带边产生的附加应力及自重等因素，推导出输送带回程分支翻转段合理的最短长度计算公式。 - Calculation of Driving Power and Belt Tension of Rubber Belt Filter
固定室水平带式真空过滤机驱动功率及胶带张力计算 - The belt tension auto-control has been the trend of the belt take-up technology.
皮带的张力自动控制已经成为皮带拉紧技术发展的方向。 - The theory analysis on the relation between saw belt tension and nature frequency
带锯条适张应力与固有频率关系的理论分析 - Check on Belt Tension of Engine
发动机皮带张紧力的检测 - In this way, it can avoid the high dynamic tension in the starting process. It can reduce the belt tension caused in the increasing stand-alone.
这样就避免了输送机在起动过程中的高动张力，降低了输送带因单机长度的增加而随之增加的拉力。 - Conveyor belt tension and power equipment faze force that act on the upper structure are the main excitation source of the transfer abnormal vibration. The production process and structure features are the source of transfer station vibration problem.
作用于结构上部的输送机皮带张力和动力设备扰力是转运站异常振动的主要激振源；生产工艺及结构特征是转运站的振动问题的根源。